V-Tec 2-wire Manuel d'instructions

1 VTEC AIR FLOW CONVERTERⅡ WIRING DIAGRAM BY MODEL This document describes car models to which the VTEC Airflow Converter II (Product code: 401-A915

10 ECU Arrangement Drawing ●Perform operations by referring to the symbols in the corresponding columns of the tables of applicable models on and a

11 How to Refer to the ECU Terminal Arrangement Drawing This ECU terminal arrangement drawing is on the assumption that the connector is viewed from

12 Table of Applicable Models Car name Car model Engine model Manufacturing year ECU position Remarks Terminal drawing VTEC No. Sensor ty

13 Car name Car model Engine model Manufacturing year ECU position Remarks Terminal drawing VTEC No. Sensor type CR-X EG2 B16A ‘92.3∼‘95.10

14 Car name Car model Engine model Manufacturing year ECU position Remarks Terminal drawing Vehicle No. Sensor type TORNEO EURO R CL1 H22

15 VTM signal ECU Terminal Arrangement Drawing IG power rpm Pressure signal Ground Throttle signal VTM signal VTEC solenoid signal rpm IG po

16 VTEC solenoid signal Ground IG power Throttle signal Pressure signal rpm Pressure signal VTC cam signal TDC signal Throttle signal VTEC

17 IG power Ground TDC signal VTC cam signal VTEC solenoid signal Throttle signal Pressure signal rpm ※It is not necessary to wire for the veh

18 Ｎｏ, Date of issue Part No. of Wiring Diagram by Model Edition Change of description 2 Aug.１, 2003 7107-0300-01 Second edition 1 May. 20,

2 Introduction “Safety precautions” are described in the Instruction Manual. Please read them before starting the installation work. “Signal words

3 Precaution on Installation ●When installing this product, do not use any electro-tap in any case. Using the electro-tap makes the contact stat

4 ●The ground conductor of this product has two branches (black and brown). This has a very important significance to secure the voltage conversion a

5 Installation ●Connecting the VAFC II １.Remove the negative (-) terminal of the battery. advice!CAUTION ！ ２.Locate the Engine Control Unit (her

6 Installation (cont.) ４.Cut the pressure signal wire or VTEC solenoid signal wire of the vehicle harness connected to the ECU and install a plug

7 Installation (cont.) ●Wire connecting method ●Be sure to connect the brown wire to the ECU side from the black wire. This product may not func

8 ●Install the V-AFC II so that it may not interfere with driving. Normal driving operations may be prevented, resulting in an accident. ●Do not in

9 ●Do not start the engine in any case before the initial setup is performed. If the engine is started without initial setup, the engine may be dama