V-Tec 2-wire Spécifications télécharger pdf (Page 13)

B. Connection for Power-- off-to-Unlock type:

+12V

LK - (GND)

LK+(COM)

N.O.

12V 300mA

EB+

EB -

Jumper set to 2-3 position

set to Normally Closed on the

Unlock Relay mode on DT software.

2. Additional power supply

DIPS

1 2 3 4 5 6

DIPS-5: set to on,

unlocking time is 5 seconds.

When the electronic lock is over 12 Vdc, additional power supply for the lock is needed.

• The power supply for the lock must be less than 48Vdc 1.5A.

•

The Jumper must be removed when using additional power supply. The default is set for Power-to-Unlock

type(Normally open), if use Power-off-to-Unlock type, change the Unlock Relay mode to Normally closed on

the Parameter tab of DT CONFIG software.

• If different unlocking time is needed to be configured, please use the DT CONFIG software to change the setting

on the Parameter tab(see the program section).

C. Connection for Power-to-Unlock type:

Note:

Cut off this line when using

additional power supply

+12V

DIPS

LK - (GND)

LK+(COM)

N.O.

1 2 3 4 5 6

EB+

EB -

Remove the Jumper

set to Normally Open on the

Unlock Relay mode.(default)

DIPS-5: default set to off,

unlocking time is 1 second.

(In most cases, 1 second is

work for Power-to-Unlock type)

D. Connection for Power-- off-to-Unlock type:

Note:

Cut off this line when using

additional power supply

+ -

Remove the Jumper

set to Normally Closed on the

+12V

DIPS

LK - (GND)

LK+(COM)

N.O.EB+

1 2 3 4 5 6

EB -

DIPS-5: set to on,

unlocking time is 5 seconds.

Unlock Relay mode on DT software.

DT - System - Technical Guide 10

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

V-Tec 2-wire Spécifications Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Interphones de porte V-Tec 2-wire