V-Tec 2-wire Spécifications télécharger pdf (Page 20)

User Code Setup

In the DT system, every apartment must have a unique identification called User Code. The DIP switches are used to

configure the User Code for each Monitor.

• Bit-1 to Bit-5 are used to User Code setting. The value is from 1 to 32, which have 32 different codes for 32

apartments.

• When multi Monitors are installed in one apartment, these Monitors have to use the same User Code setting,

and the Master/Slave mode should be set on the Monitor.

• Bit-6 is line terminal switch, which have to be set to ON if the Monitor is in the end of the line(bus), otherwise set

to OFF. The end of the line is terminal that no other section will start from it.

Bit-6 line terminal setting:

ON(1) OFF(0)

Bit state Setting Bit state Setting

2 3 4 5 6

= =

1 2 3 4 5 6

Monitor not at

the end of the

line.

1 2 3 4 5 6

Monitor at

the end of

the line.

Bit state User Code Bit state User Code Bit state User Code

1 2 3 4 5 6

Code=1

Code=2

Code=3

Code=4

Code=5

Code=6

Code=7

Code=8

Code=9

Code=10

ON ON

Code=12

1 2 3 4 5 6

ON ON

Code=13

1 2 3 4 5 6

ON ON

Code=14

1 2 3 4 5 6

ON ON

Code=15

1 2 3 4 5 6

ON ON

Code=16

1 2 3 4 5 6

ON ON

Code=17

1 2 3 4 5 6

ON ON

Code=18

1 2 3 4 5 6

ON ON

Code=19

1 2 3 4 5 6

ON ON

Code=20

1 2 3 4 5 6

ON ON

Code=21

1 2 3 4 5 6

Code=23

Code=24

Code=25

Code=26

Code=27

Code=28

Code=29

Code=30

Code=31

Code=32

1 2 3 4 5 6

Code=11

Code=22

1 2 3 4 5 6

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

V-Tec 2-wire Spécifications Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Interphones de porte V-Tec 2-wire